|
Fluke
5100B Calibrator
|
Multifunction calibrator
Generates VDC, VAC (20mV-1100V, 0,1 µV resolution),
IAC and IDC 0-2A,
R 0-10MOhm.
Accuracy +/- 50 ppm
link to manufacturer
|
|
Fluke
8846A Precision Multimeter
|
6.5 digit Precision Multimeter
Basic V dc accuracy of up to
0.0024 %
100 μA
to 10 A current range, with up to 100 pA
resolution
Wide range from 10 Ω to 1
GΩ with up to 10 μΩ resolution
2 x 4 ohms 4-wire measurement
technique
measures capacitance and
temperature
Trendplot™
paperless recorder mode, statistics, histogram
CAT I 1000 V, CAT II 600 V
Link to manufacturer
|
|
HP
34401A Multimeter
|
6 1/2 Digit DMM
35ppm basic DC V accuracy
100nv resolution
1000 rdgs/sec
reading rate
512 sample memory
RS232C & HP IB Interfaces
link
to manufacturer
|
|
HP
33120A Arbitrary Waveform Generator
|
15 MHz sine and square wave
outputs
12-bit, 40 MSa/s, 16,000-point deep arbitrary waveforms
Sine, triangle, square,
ramp, noise and more
Direct Digital Synthesis for
excellent stability
High-Stability Time Base and
Phase lock Loop (PLL)
link
to manufacturer
|
|
Instek APS 9501 AC Power Source
|
AC Power Source
Wide Range Variable Output
Voltage/Frequency
Stable and
Low-Distortion Output Waveforms
Software
Calibration to Ensure Accuracy
Panel-Lock
Function to Prevent Accidental Wrong-Operation
Over Current Protection
and Over Temperature Protection
Link to
manufacturer
|
|
HP
5316A Universal Counter
|
Frequency, Period, Ratio, and totalize to 100MHz
User Reciprocal technique for full low-frequency
resolution
100ns Time Interval, 10 ps
T.I. Averaging
HPIB capability
link
to manufacturer
|
|
HP
3456A Multimeter
|
6.5 Digit Display
Up to 330 readings per
second
100 nanovolt
resolution
Transfer standard
performance
Fast AC
100 micro-ohm to 1.0 G-Ohm
measurement capability
Offset compensated ohms (OC
Ω)
link
to manufacturer
|
|
HP
214B Pulse Generator
|
100 V, 2 A maximum output into 50 Ohms
10 Hz to 10 MHz rep rate
(4 MHz max in 30 V to 100 V output range)
Constant duty cycle mode for device protection
link
to manufacturer
|
|
Tektronix
TDS 3012 Scope
|
Advanced waveform capture, display,
and measurement capabilities
Number of Channels: 2
Bandwidth: 100MHz
Sample Rate on Each Channel: 1.25 GS/s
Display Monitor: Color LCD
link
to manufacturer
|
|
Tektronix
468 Scope
|
100 MHz analog oscilloscope
10 MHz single shot digital storage
Cursors for time & voltage measurements
Dual time base with B-delay
link to
manufacturer
|
|
Tektronix AM 503
Current Probe Amplifier
Tektronix
A6303 Current Probe
|
100 A Ac and Dc Current Measurements
Peak Pulse Measurement to 500 A
Ac or Dc Coupling
25 x 21 mm (1 x 0.83 in) Jaw Opening
link to
manufacturer
|
|
Tektronix 576 Curve Tracer
|
Measures DC parameters for 2 & 3 terminal
semiconductors
up to 220 Watts with readout of scale factors.
link
to manufacturer
|
|
Metrel MI 2170 Multiservicer
|
High-voltage AC dielectric test with test voltages
2500V and 1000V with selected leakage current trip out,
DC insulation resistance measurement,
PE continuity test,
10A earth bond test,
discharge time measurement,
leakage current measurement and functional test.
link
to manufacturer
|
|
Fluke 179 Multimeter
|
True-rms
ac voltage and current for accurate measurements on non linear loads
Large digit display with
analog bargraph
Display backlight for work
in dark areas
Temperature and capacitance
Records minimum and maximum
values to aid in troubleshooting
Free your hands with the
magnetic hanger included in this combo kit
Durability backed up with a
limited lifetime warranty
Includes thermocouple
probe, integral holster and test leads
Link
to manufacturer
|
|
Fluke 189 Data
Logging Multimeter
|
50,000 counts display
0.025% basic DC accuracy
True RMS AC + DC
measurements
100 kHz AC bandwidth for
voltage and current
Ergonomic high-impact overmolded case
Dual display with bargraph and two-level backlight
Min/max/average with real
time clock
250 µs Fast Min-Max
Frequency, capacitance,
duty cycle & pulse width meas.
Resistance, conductance,
continuity and diode meas.
Temperature and dBV/dBm with selectable reference
link to manufacturer
|
|
Fluke
8060AA Multimeter
|
True RMS AC, Useable to 100
kHz
Frequency Measurements to 200 kHz
Basic DC Accuracy +0.04%
4 1/2 Digit Display
Conductance and Audible-Visual Continuity Functions
link to manufacturer
|
|
Fluke
8020B Multimeter
|
AC Current 2 mA - 2000 A 
AC Voltage
Range 200 mV - 750 V
DC Current 2 mA - 2000 mA
DC Voltage
Range 200 mV - 1000 V
Number of
Digits 3.5
Resistance Range 200 ohm - 20 Mohm
link to manufacturer
|
|
Fluke
8024B Multimeter
|
VDC
200 mV, 2V, 20V, 200V, 1000V
VAC 200 mV, 2V, 20V, 200V, 750V
CMRR: >100 dB at dc, 50Hz and
60Hz
ADC 2mA, 20mA, 200mA, 2000mA
AAC(True-RMS) 2mA, 20mA, 200mA, 2000mA
RESISTANCE 200Ω, 2kΩ, 20kΩ, 200kΩ,
2000kΩ, 20MΩ
CONDUCTANCE 200 nS
Equivalent 5MΩ to 10,000 MΩ
3.5 digit LCD (1,999 count)
link to manufacturer
|
|
Instek GPM 8212 Power Meter
|
Voltage 5 V – 640 V
Max. Input Voltage 1000V (peak), 700V (rms)
Current 120 mA – 20.48 A
Max. Input Current 30A (peak), 20A (rms)
Accuracy (at 23°C+5°C) + 0.1% of reading +
0.1% of range
Watt
0.32 mW - 13.10 kW
Accuracy (at 23°C+5°C)
+ 0.2% of reading + 0.2%
of range
link to manufacturer
|
|
Instek GOM-802 Miliohm Meter
|
Test Ranges: 30 mΩ, 300
mΩ, 3 Ω, 30 Ω, 300 Ω, 3 kΩ 30 kΩ, 300 kΩ and 3 MΩ 9ranges
Resolution: 1 µΩ
30000 Counts Display
High Accuracy 0.05%
Hi/Lo Comparator and Limit Percent Setting
Measurement of REL, Actual and % Value
Manual or Autoranging
Continuous or Triggered Measurement mode
Temperature Compensation and Measurement
Four-Terminal Measurement Technique
link to manufacturer
|
|
Instek GDM-8264 Digital Multimeter
|
50000 counts DMM
Multi-function ACV, DCV, ACA, DCA, R, C, Hz,
Continuity Beeper, Diode
Test, Max/Min, REL, Hold, dBm,
Compare
Dual Display Indicate ACV and Hz or DCV(ACV) and dBm
Manual or Autoranging
0.02% DCV Accuracy
ACV Measuring Frequency up to 100kHz
20A Current Range With High Energy Fuse
Protection
Auto-Recall the setting Upon Power ON
AC True RMS or AC + DC True RMS
link to manufacturer
|
|
Instek GPT 715 HV Tester
|
AC, DC Withstanding Voltage Test
Insulation Resistance Test
100VA Test Capacity
Arc Detect and Continuity Check as Additional Features
Linear amplifier with feedback control to provide
highly regulated power
link to manufacturer
|
|
Hameg HZ 530 EMC PRE-EMI Set
|
Frequency Range:
0.1 MHz to 1000 MHz (lower frequency limit depends on probe type)
Output Impedance: 50W
Output Connector: BNC
Input Capacitance: 2pF (high
impedance probe)
Max. Safe Input Level:
+10dBm
1dB-Compression Point: -2dBm
DC-input Voltage: 20V max
link to manufacturer
|
|
LEF
DG50 Teslameter
|
Ranges: 300µT,
300mT, 30mT, 300mT, 3T, 30T/
3G,30G, 300G, 3Kg, 30Kg, 300Kg
Resolution: 1
mG (0,1 µ T) to 100 G (10 mT)
Measure: tesla, gauss, amper/meter
(switch)
link
to manufacturer
|
|
HP 4275A Multi-Frequency LCR Meter
|
Test frequencies:
10 kHz to
10 MHz
Test signal level:
1 mV to 1 Vrms (4275A)
0.1% basic accuracy
Measure L/C - D/Q/ESR/G; IZI - e, R-X/B/L/C; DLCRZ, D%
High Resolution - 5.5 digit; D=0.00001
Options:
001 - 0 to ±
35V Internal DC Bias
002 - 0 to ±
99.9V Internal DC Bias
004 -
Frequency steps in 1,3,5 Sequence
link
to manufacturer
|
|
Lutron FG-5000A Force
Gauge
|
5000 g, g/oz/Newton.
Tension & Compression, Peak hold,
Zero, Positive/ Reverse display, 5 digits LCD.
Full line accessories, optional test stand.
Link
to manufacturer
|
|
Lutron DT-2268 Photo/Contact
Tachometer
|
Photo tach. : 5
to 100,000 RPM
Contact tach. :
0.5 to 19,999 RPM.
Surface speed :
m/min, ft/min.
Large LCD display, 20 mm digit height.
Laser light beam for Photo tachometer.
Link
to manufacturer
|
|
Digitron 2083P Pressure Meter
|
Pressure ranges from 2mbar to 7bar
(2" H2O to 101.5PSI)
Scales in mbar, bar, PSI, inH20, inHg, mmH 2 0, mH 2 0, mm/cm/mHg, Pa and kPa
Accurate performance: 0.2% of reading
Automatic zero calibration for added
accuracy
Link
to manufacturer
|
|
Mitutoyo ID-C 543
Indicator
|
Resolution: 0.01mm, 0.001mm,
.0005"/0.01mm, .0001”/0.001mm or .00005”/0.001mm
Display: LCD
Length standard: ABSOLUTE electrostatic
capacitance type linear encoder
Max. Response speed: Unlimited
Link
to manufacturer
|
|
Mitutoyo CD-15 500 Caliper
|
Resolution: 0.01mm or .0005"/0.01mm
Repeatability: 0.01mm / .0005”
Display: LCD
Length standard: ABSOLUTE electrostatic
capacitance type
linear encoder
Max. response speed: Unlimited
Link
to manufacturer
|
|
Kern F1 Sets of Weights
|
Sets of reference weights of accuracy
class F1
Link to
manufacturer
|
|
Set
of HP Test Probes
|
|
|
Set
of Tektronix Test Probes
|
|
|
Set
of HP Power Supplies
|
|
